发表文章

[C] 运行 0.9_beta9.9 9-5 在 OpenWrt 障碍断路器最后发行。 Running 0.9_beta9.9.9-5 on OpenWrt Barrier Breaker final release.[nodogsplash]

bluewavenet 2017-10-9 45

我不得不使用屏障断路器的项目, 因为 OpenWrt 混乱平静的 Ubiquiti AirRouter 是打破了-至少是刚刚现在。
安装 0.9_beta9.9 9-5 后, 您将必须替换已安装的 init. d 脚本中的版本
0.9_beta9.9. 8 和在附上文件这里否则 Nodogsplash 无法开始。
nodogsplash。

完美的工作后。我还没有时间调查导致问题的原因, 但是这个修复工作。

原文:

I am having to use Barrier Breaker for a project as OpenWrt Chaos Calmer for Ubiquiti AirRouter is broken - at least is is just now.
After installing 0.9_beta9.9.9-5 you will have to replace the installed init.d script with the version in
0.9_beta9.9.8 as in the attached file here otherwise Nodogsplash fails to start up.
nodogsplash.init.d.txt

Works perfectly after this. I have not had time to investigate what is causing the problem, but this fix works.

相关推荐
最新评论 (6)
bluewavenet 2017-10-9
1

好吧-现在看看这个9.9. 9-5 init. d 脚本无法启动 NDS/等/配置/nodogsplsh 有-
选项已启用0。更改为启用的选项1应修复此问题。

原文:

OK - now looked into this. The 9.9.9-5 init.d script fails to start NDS as /etc/config/nodogsplsh has -
option enabled 0. Changing to option enabled 1 should fix this.

mwarning 2017-10-9
2

@bluewavenet是将启用的设置为 1, 这是唯一的问题;在这种情况下, 我会关闭票。由于这是安全的默认值 (afaik, NDS 将使用默认选项将您锁定, 并启用设置为 1)。

原文:

@bluewavenet is to set enabled to 1 the only issue here; in this case I would close the ticket. As this is the safe default (afaik, NDS will lock you out using the default options and enabled set to 1).

bluewavenet 2017-10-9
3

我不确定。我有一个工作. 部署所需的, 并使它的工作, 恢复到原来的 inet. d 脚本, 并没有时间回顾更详细。
我们需要这个吗?它是一个不必要的复杂性, 还是它有我没有时间考虑的潜力?它似乎是一个反复出现的问题-人安装, 它无法启动。
顺便一道-在混沌平静的电流 Openwrt 释放是岩石固体 CC 和 BB。我们有一个酒店/餐馆/酒吧, 平均每天超过第300客户端 (在 PC 引擎 Alix 2d2 喂养到9接入点)。

原文:

I'm not sure. I had a working .conf needed for a rollout and made it work by reverting to the original inet.d script and have not had time to look back in more detail.
Do we need this? Is it an unnecessary complexity or does it have potential I have not had time to think about? It seems to be a recurring question - people install and it fails to start.
By the way - the current Openwrt release in Chaos calmer is rock solid on CC and BB. We have a hotel/restaurant/bar running with an average of over 300 NDS clients per day (on a PC Engines Alix 2d2 feeding into 9 access points).

mwarning 2017-10-9
4

@bluewavenet请尝试当前版本, 并检查它是否适用于您

原文:

@bluewavenet please try the current release and check if it works for you

bluewavenet 2017-10-9
5

我尝试了 0.9_beta9.9 9, 因为在 CC 上使用这个来进行展示。更改 init. d 脚本包括 START=198 似乎做的伎俩。
问题是由 nds 在启动 nds 时使用的接口引起的。然后卸载。
START=198 使 init 在开始 NDS 之前等待更长的时间。
我还没有时间进一步调查。

原文:

I experimented with 0.9_beta9.9.9 as was using this on CC for a rollout. Changing the init.d script to include START=198 seemed to do the trick.
Problem is caused by the interface used by NDS not being UP when NDS starts. NDS then unloads.
START=198 makes init.d wait longer before starting NDS.
I have not had time to investigate further.

bluewavenet 2017-10-9
6

V1 和 V2 的作品很好

原文:

Works fine in V1 and V2

返回
发表文章
bluewavenet
文章数
12
评论数
183
注册排名
60902